For Latest Keys See Dooby2oons Site
ALL IN ONE GUIDE UPDATED 100% WORKING
Starview box manual key input guide
By Dooby2oon
Entering keys manually works fine.
Works with all firmware except 258 as known to have issue's with getting secret menu up
also no need to scan/reset just follow instructions below
To put keys in manualy do as follows.
Press menu button
Press 1570 this takes you into secret menu as shown below
Now hit ok on nagravision
Next make sure your cable provider is listed at top NTL or TELEWEST C&W ect
Now change key 00
(YOU MUST SAVE EACH KEY INDIVIDUALLY - I.E. AFTER CHANGING KEY 00 MAKE SURE
YOU STORE BEFORE CHANGING KEY 01 (TO STORE PRESS OK)
Right now change key 01 (To change between the 2 keys highlight key number press right and left )
Please Dont forget to store key again press ok
If you've done full factory reset/scan dont forget to turn the EMU back on
>> AND DO NOT PRESS SET DEFAULT KEY OR WILL RESET KEY CHANGE ABOVE <<
Now exit and all channels ok
Be warned that
VIRGIN MEDIA ARE CHANGING THE KEYS WEEKLY OR EVEN DAILY !
Buttons on the starview remote:
Pause button = Letter A
Audio button(next to pause!) = B
Red button = C
Green button = D
Yellow button = E
Blue button = F
To enter numbers use the numbers on the remote 0-9.
To move left or right use the navigation buttons left and right.
To confirm press ok.
----- MANUAL INPUT FOR REPLAY & LITE ---------
1. Menu
2. Installation
3. Parental Lock
4. Red Audio Button for Goto Key Manager
5. Choose the top option and turn OFF the auto update.
6. Press the Blue button to choose the NAGRA option
6. Three left arrows back take you to 'Prov ID 0x5B' which is TW 4 back is 'Prov ID 0X55' is Ntell and 0XC1 is ex C&W etc
7. One down arrow takes you to the 0x00 - i.e. Key 0. Press OK
8. Up pops the HEX Keyboard - just type in the new numbers (Enter your cable companys keys from above)- it puts the dots in for you. Do this for Key 01 as well.
9. Exit out -should be sorted.
Members
Total Members: 302
Stats
Users Online
